We Offer Quantity Discounts on Generator Units.

Call Us for Details!

Controllers

R-100 Digital Controller

Generac's R-100 Digital Controller with built-in governor control monitors the utility voltage and displays system faults such as overcrank, overspeed, high coolant temperature, low coolant level, low oil pressure and low battery. This high-quality controller also oversees the transfer switch, exercise function and, on the Quiet-Test^TM feature.

R-100 Digital Controller Specifications:

7 LED Indicator Lights	Standard
High Temperature Shutdown	Standard
Low Coolant Level Shutdown	Standard
Low Oil Pressure Shutdown	Standard
Overspeed Shutdown	Standard
Automotive Voltage Regulator with Over-voltage Protection §Voltage Regulation (at steady state from no load to 100% load) § Frequency Regulation (for constant load from no load to 100% load)	Standard  1.0%  0.5%
Engine Start Sequence	Cyclic Cranking:  Initially 15 sec. on, then 7 sec rest, 7 sec. on 90 sec. maximum duration.
Safety Fuse	Standard
Starter Lockout	Starter cannot re-engage until 5 sec. after engine has stopped
2 Amp Battery Charger	Standard
Engine Warm-up	10-15 seconds
Engine Cool-down	1 minute
Mode Switch §Auto Position § Off Position § Manual/Test Position	Utility failure / 7 day exerciser Stops unit.  Power is removed.  Control and charger still operate. Start on starter control, unit stays on.  If utility fails, transfer to load takes place.
Automatic Weekly Exerciser with Selectable Low Speed Exercise	Standard

PowerManager® H-100
Generac's new PowerManager® H-100 brings generator control and monitoring to a new level of sophistication.  It's not only ahead of the competition; it's ahead of his time.  This full-featured controller boasts 32-bit processing for quick and simultaneous monitoring of all key generator functions, including engine protection, voltage regulation and governor regulation.  The Powermanager® H-100 is also remotely accessible through a laptop with optional modem and GenLink® software.

PowerManager® H-100 Controller Specifications:

32-Bit Microprocessor	Single point of control for engine, generator and transfer switch functions
Automatic Voltage Regulator with Over-voltage Protection § Variable Voltage Frequency Settings § Voltage Regulation     (at steady state from no load to 100% load) § Frequency Reglation     (for constant load from no load to 100% load) Sealed Casing Low Coolant, High Temperature and Low Oil Pressure Automatic Shutdown	Standard Allows matching V/F to load for more consistent output; prevents excessive engine lugging under load to protect motors and improve motor starting.  0.25% Isochronous Protects against vibration, dust, heat, moisture, corrosion, radio interference, electromagnetic interference, and static discharge Standard
Digital Readout of AC, kW, kVA, Power Factor and All Engine    Functions	Standard
Isochronous Governor Control	Standard
Predictive Maintenance Reminders	Standard
3 Phase Sensing	Protects motor by monitoring voltage across all 3 phases
2 Amp Automatic Battery Charger	Standard
Fault Protection (I2T Function)	Provides total generator winding protection under all fault conditions
Start/Stop Control	Programmable auto-crank feature
Starter Lockout	Standard
Overspeed/Over-voltage Protection	Standard
Overcrank Protection	Standard
Emergency Stop	Standard
RS485 Remote 2-way Communication with HTS Transfer Switch	Standard
RS232 & RS485 Outputs	Computer connections for remote monitoring and remote adjustments (with optional modem and GenLink® software).

Phone: 716-565-6223 | Fax: 716-565-0506
Call Toll Free: 1-877-711-5432
generators@AceEnergyusa.com

Copyright 2006 Ace Energy Company, Inc.